• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Recent content by bronco italiano

  1. B

    Hydroboost fittings

    Nice area, I am a little North of you. Call Lee pwr steering, they has very nice parts and can get you sorted out. I never amazon/ebay on high pressure hydraulic parts.
  2. B

    Fuel tank options with sniper EFI

    If your plan is sniper all the way, check tanks inc., they may have the properly rated in-tank pump for sniper (58.5psi?). I tried the gravity feed for my buddy's bronco, he has two aux tanks, and I couldn't get the LP pump to pull as I liked and the third tank had no return provision so I...
  3. B

    Hydroboost fittings

    Lee power steering. What part of ID are you in?
  4. B

    33s & AOD transmission-Any Lift advice

    I am very pleased with my AOD, it was built/modified by a professional tranny shop, I use an actual pressure gauge to make sure I am right on with TV pressure. I went 4:11 gears on 31" tires and places my peak torque at about 2900 rpm. Highway could use 4:30 probably.
  5. B

    1977 column turn signal connector?

    Yes, that looks close but Ford has the little red inner piece that holds the pins in.
  6. B

    1977 column turn signal connector?

    Thanks, checked both and nothing even close to the factory style connector
  7. B

    1977 column turn signal connector?

    I just looked at WH and DC site but could not find the factory style column portion of the turn signal switch connector. Anyone reproducing them?
  8. B

    Hydroboost help needed

    If it is used, you should rebuild it. Kits are like 40$
  9. B

    Hydroboost help needed

    Which vendor did you get the system from? Pictures of line routing?
  10. B

    SOLD 1 gal of SPI gray epoxy primer + 1 gal activator - New, never been opened cans

    I will take it. Shipping to 95212 I may have you ship it to 90036 Do you mind getting me a cost for shipping to both zip codes please
  11. B

    2000 explorer 5.0 swap- return less fuel system requirements

    Yep, that is a good one. I have a RobbMC version, probably made by aeromotive. https://www.robbmcperformance.com/products/regulator_fi.html
  12. B

    Fitting 351W + Q-jet Carb under stock hood -- Econoline intake?

    Offenhauser made a 351w qjet intake. Bery hard to find. Ford did a thermoquad and not sure if the bolt pattern would ne the same.
  13. B

    CA Misc bronco parts

    Yes. I can also deliver parts to WH in May at their roundup
  14. B

    CA Misc bronco parts

    I also have a rebuilt Edelbrock 600 off road carb for 250 electric choke comes with calibration kit was re-jetted for 351 CID
  15. B

    Fitech back to Carb....

    There are many "remote tuners" out there that may be able to help you out. Going back to carb type depends on what you are going to do with your bronco. Off-roading, "Mall crawling", daily driver, etc.
Top