Recent content by Danadj

I'm having the same issue with my gauges, output on the (IC) IVR is 5v until you attach the gauge connection. I disconnected the oil pressure gauge and now I have intermittent temp and fuel gauges.

Well, good news. After soldering the wire in the back of the fuse box, I discovered two wires got swapped in the wire loom connector going into the steering column (Blue and Blue-white stripe). Then after scraping some of the corrosion from the fuse tabs, I now have both the EM flashers and...

I took the fuse panel off the firewall and the Blk-Yel striped wire had broken off at the back terminal because of corrosion. I've cleaned the end of the wire and the terminal plate and now I have to figure out the best way to reattach it. Maybe soldering? I'm open to ideas, definitely don't...

I did some testing at the fuse box with ignition on there is power to the turn signal fuse but no power to the Emergency flasher fuse. On the wiring diagram the power source wire (Black-Yellow stripe) for the flasher appears to be coming from the alternator

Will do once I'm back home. Thanks,

Steering column is stock and wiring harness is stock, I removed shift linkage and cut the original shaft to replace with the collapsible shaft. The flasher is the stock dash switch. this issue began before the column modification, I was just hoping disconnecting and reconnecting everything...

I replaced the signal switch after I got the truck and it worked fine for a while then stopped then started but lately nothing. Changed the relays with no results. I recently replaced the 3 Spd with a NV3550 and I just pulled and cleaned up the column to convert to PS so I'm quite sure the...

No luck on wiggling the switch. Just to clarify, when the flasher switch is on the brakes are applied, the cluster turn signal lights come on, When brakes are let off, they go out.

It is a relatively new switch but I'll check it out.

Tail lights work fine including brake lights. Flashers don't work but when the switch is on, the turn indicators in the cluster both light up. Also, when the brake is pressed and the brake lights are on and the turn signal is put to the left or right the corresponding brake light goes out...

I don't want to say for sure on which ones I removed but I avoided removing any that had the clamps attached. I believe the second largest and midway down and it dropped the rear down between 2 and 3". If I knew how to attach photos, I would show you a before and after shot.

I installed WH 2-1/2" lift springs and removed 2 leafs and the back is still a little high but not so much that I wanted to tear it apart a third time.

What is the color code on your Vin? Mine is K which doesn’t appear to show up on the vintage charts I’ve seen. What I do see in 68, 69, and 70 is a color code W and it is called Meadow Lark or just Yellow. I had a local paint store scan the paint on my truck and it didn’t go so well.