Recent content by desertbug

I don't have the aux tank, but if I remember right, the bolts holding the brackets in on the driver side went into "attached/welded" nuts on the underside. Wasn't that hard - 4 bolts on driver side, but several more on the passenger side (bolts in front only). If you're going to look for...

I'm sure this isn't "cheap," but it DOES look rather rugged. My hope is that with the introduction of a Can-Back for both the Early and Late model Bronco's (YES - I want BOTH!!!), there's finally some good old-fashioned competition for the already overpriced flimsy soft-tops available now...

I've always been satisfied with my hard top in winter and no top in spring-fall, and have always wanted some sort of roof rack to stow gear as well, but that would equate to a winter only operation... This thing is an AWESOME (long overdue) product! If it's as airtight as Chuck says it is...

I've got some older "white spoke" 15x12's with 33" Kelly's (NOT anywhere near new) and they had been "shaking" around 50 mph. Took 'em up to Les Schwab and they tried to balance them once (about a ton of weight on one of them) and took 'em back for another attmept, this time standing there...

Replaced the stock seats with some easier on the "bum-bum" seats out of a Bronco II. Slipped in just fine and covered them up.

Crawled up Rattlesnake Hill here in town for a breath of fresh air and a few cold drinks

Here's both Bronco's - the 69 and 96 (completely stock for now)

Just outside of the NAVY base out here in the desert. If you crawl up a rocky slope to watch the sun go down, make sure there's a full moon!

:o WHOA! GREAT FIND, Waverous! Both the front and back sets are SWEET!!! Makes me want to run up to the Quik-E-Mart and play a couple scratch-offs... It's always nice to see a rear bumper set-up done for "regular people" that will carry a tire and gas and leave off the cheesy ice cooler...

Back to the original question on 16" - isn't it a little harder to find (non-street) tires for the larger rims/wheels (16, 17")? If so - aren't they a little more expensive? 15" seems to be the best standard out there - espeically considering availability and price - although once you get...

Whatever the deal is here, I guarantee the seller and future buyer gets the "muchies" a lot

The sun's starting to go down - I hope this turns out ok. Here's the final product. Based on the mockery from Mrs. DB - these are "intermediary" seat covers until some others can be found that are a little more pleasing to the eye....:

Is this thing the bracket you're looking for?

Sure thing, I-Mike.... lemme see if I can figure this pic post thing out.... Brad - I didn't use the "tilt-fwd" bracket out of the passenger seat... I'll see if I can get a pic of that up here too. You're welcome to it if you want it. Be right back after some html practice :p