Recent content by Gupster88

Sone. What ya after?

Think we have been down this road before. But this is what I have . 15 miles south of Tillamook on HWY 101 . Not sure on size. In Alaska right now

15.9? You need to take your foot outta it. I am pushing 18mph with the tune kit.

Gupstr

Sold all of em except one. Guy came to buy one and left with three…. Told him what I wanted. He wrote a check…. Was a very sad day. Just have the 1970 Boxwood Green left…..

347 stroker with roller cam and aluminum heads. Built by professional engine builder and ran on stand upon completion. 750CFM Edelbrock carb. 415 HP with 385 pounds torque on paper. Includes new alternator , fan blades , Triflow 4 core radiator , bell housing , clutch , flywheel , flexplate ...

put a price on them.

U15GLH if read correctly is good. Now last 5 should all be numbers

So far what you have there is a 1970 hard top with 302 engine. Last 5 should all be numbers

Check again. last one should be a number. Not a letter

Never mind. Figured it out. Dip stick that put the tranny on the motor ran those studs thru the wrong hole. Gotta pull the tranny loose and hope studs are not damaged and get them in right hole. Arrrgh!

Ok guys. Got the 408 stroker fired up today. Runs like a top. However terrible rattle from C4 tranny. It appears torque converter is loose. See attached photo. Is there a nut of some sort that goes on that stud. It seems to be what’s loose . All for studs seem to be rattle point. I am not a...

Getting 18.2 ish with my 2024 Raptor with tune kit. Only have 1000 miles on it and driving country curvy roads. Running 91

What ya need?

I would only use it if you install tune kit. Highly recommended if tune kit installed. If not. Then 87 is fine.