Recent content by migs

Well it moves on it's own again. The no spark issue was just dirty points and bad grounds. So I got the new "fuel cell" secured and cranked away. Well the float was stuck open and the fuel pump works so well that it launched the fuel out of the overflow tube right over the cowl and up onto the...

Thanks! Been through a few different combos over the years... on this page in my thread shows when I went to the current set up of 275 toyo's on 17" Method wheels. Originally had that same smaller size on white steel wheels, should be pictures of that as well in there back a few pages. Will...

Back to the “top”;) winter is coming. Will listen to offers

Yup, i remember that one, very cool truck. it's funny too that the majority of patina builds always seem to be some shade of a teal to green color.... must've been something special in that particular paint color that preserved those old vehicles better!:LOL:

Alright, the floor pan paint is dry, ready for some nice floor mats. 😁 And since the Marti report said it came with a right side mirror, i installed one on each side. Also, here's a picture from when I pulled it out of back yard storage a couple of months ago. Looks much happier now.

Ok, so in the continuation of the patchwork theme on this Bronco, the "temporary" floor pan is now installed. I used aluminum pop rivets and seam sealer to install it so it could be more easily removed down the road should someone wish to do so, vs just welding a big flat panel over it as they...

You're welcome! Made a quick "temporary" floor pan out of 10 gauge aluminum to cover the big hole where the original driver's floor pan used to exist. Goes well with the custom Swiss stainless kick panel.

Here's the stats from the Marti report. Also at some point a 200 six was swapped in in place of the 170 092 Wheelbase (inches) N Norway Paint U152 Bronco Wagon 4700 Lb. GVW 9U Parchment Rosette Bucket Seats w/Rear Seat C 3-Speed Manual Transmission A5J 4.11 Limited Slip Rear Axle / Dana 30...

Yeah, I get it(y) I got too many and can’t afford to buy parts for them:LOL: trying to use up spare parts here on this one. But it’s growing on me now….might be hard to actually let it go in the end.

I’ll have to check on that later today. Can give the exact dates as I have a marti report on it. I know the dso was New Jersey and was ordered as a fleet vehicle or something. Also with limited slip differentials front and rear.

Well, make an offer and hook up the trailer :cool:😁 I think I do have a windshield to go with it. Thanks for the compliments on it everyone. I’m enjoying tinkering on this one, figure whatever I do can’t possibly make it any worse!

she's alive!! well, the lights any way😁 I could've went with some old tattered ripped seats, but I think it deserves the nice ones.

More improvements for the 69. Someone will be getting some nice seats at least. 😄 Also found an ash tray, a decent dash pad and a horn button as well in my stash. Installed the headlights, and they work! So the starter in it turned out to be dead, first old used replacement starter took a few...

Ha! I almost did, but I have better ones to work on….and realistically not enough time as it is😁

Selling my set of Yokohama tires on Dodge wheels, great for a lifted uncut Bronco. Tires are 285/75r17 on 17x8 factory Dodge Ram 1500 steel wheels of which I machined the center bore out to fit over the Bronco hub. Also including a fifth wheel without a tire. Only put a few hundred miles on them...