• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Recent content by moses_m

  1. moses_m

    NV3550 Internal upgrades?

    TTT Did u find upgraded internals and what is the name of the chrysler oil??
  2. moses_m

    Car has a hard time starting after it's been running

    Searched this post. Which spacer did u use? Do u remember? Running a truck avenger carb.
  3. moses_m

    Serpentine belt routing

    Installed this belt last night on this setup. It was a job getting it on. Is it suppose to be real tight?
  4. moses_m

    Fuel Pressure on Carb?

    TTT My question is Do I need a vented or a non vented gas cap?
  5. moses_m

    Floor Board heat help and suggestions

    Just drove my bronco from West Odessa TX to Yuma Arizona (15hrs) and the heat coming from the floor board was intense. It didn't help that I was running the heater to help the engine cooling as the temps were well over 100 during the day. But I need to do something about the floor board heat...
  6. moses_m

    Fuel Pressure on Carb?

    Bronco is running good. Just drove it round trip from Odessa TX to Yuma Arizona. 15hrs one way. Most of it at night driving. I have a air leak somewhere as the fuel pressure at carb works off and on. My question is Do I need a vented or a non vented gas cap? Also looking for some...
  7. moses_m

    Fuel Pressure on Carb?

    Will work on it Friday. Will update then
  8. moses_m

    Fuel Pressure on Carb?

    TTT My issue is I am not getting fuel pressure at the gauge by the carb. Fuel tank is 3/4 full. I have the regulator, and fuel pump relay, bolted to the fire wall by the master cylinder. No oil switch installed. Going to bypass regulator first. Then going to run some new hose from pump to...
  9. moses_m

    Fuel Pressure on Carb?

    Carter P4070 installed 2014
  10. moses_m

    Fuel Pressure on Carb?

    TTT I think i am good on volume. Running 3/8 fuel lines. Just ran it 80 mph 5 miles west then 5 miles back home. Got the temp up to 200 and it stayed there. Got home turned it off. Came right back on. Waited 15 more turned on no issues. Did not have to give it gas. Still no pressure on...
  11. moses_m

    serpentine belt/pulley conversion questions

    Explorer setup is great. All the info is in the bronco tech articles. Sandman i believe is his name has all the parts. 96 to 01 explorer. All the damper info is on the article as well. I have used dampner dudes twice they know exactly what you need when u call them.
  12. moses_m

    Fuel Pressure on Carb?

    Will check lines today and venting as well.
  13. moses_m

    Fuel Pressure on Carb?

    Installed a holley truck avenger carb with a holley regulator. Starts fine and I have pressure when i start it 7 to 9 lbs. Once the engine is warm I lose all fuel pressure. Do i need a different regulator with a pressure relief back to tank. I have adjusted the float levels on carb like the...
  14. moses_m

    Shaking Issues possible Clutch Chatter

    Issue resolved transadapter plate that mates tranny and bell housing was not fully seated. Tightened all bolts on plate.
Top