• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Recent content by Original77

  1. O

    Adding/Running a Power Brake Booster with Low Engine Vacuum

    Hey TOOLMAN, do you know how much vacuum your engine is creating? Living in Denver, I would think you are lower than average too.. I'm just wondering how low on the vacuum I can be at altitude and get by using a power brake booster.
  2. O

    Adding/Running a Power Brake Booster with Low Engine Vacuum

    I believe the altitude is the biggest killer of my vacuum, sources on the internet say you can lose up to 1 inch of mercury for each 1000 ft above sea level, roughly. So at sea level, I'd bet I'd close to 16-17, which would be normal range for power brakes.
  3. O

    Adding/Running a Power Brake Booster with Low Engine Vacuum

    Its a stock Bronco, I recently swapped out my power valve on the carb to a 5.5 and it runs so much better (The PV should also be picked according to engine vacuum). No gasket/spacer on the manual master cylinder, I don't think the Booster option was ordered when the Bronco was new. The manual...
  4. O

    Adding/Running a Power Brake Booster with Low Engine Vacuum

    I have a 1977 Bronco with Disks up front and Drums in Back. I do not have a Power Brake Booster, I'm not sure if one was ever installed on the vehicle. I have about 11 PSI on the vacuum meter when testing at idle, or when the Bronco is in Drive Gear with the brakes applied. I live at 5800...
  5. O

    Fabricating a Rear Storage Box

    Tech article by Brandon Freking (Original77) I'm always looking for more lockable space in my Bronco. The space behind the rear seat in an early Bronco does afford some area, but you can be limited by the rear fender wheel wells and roll bars if you have them. I found that the diamond-plate...
Top