Recent content by pmansfield64

Thanks everyone. Hopefully can fabricate and install before the Super Celebration in Townsend, if not we're going with 2wd,

Anyone ran into this? Driveshaft touching crossbar.

Will this work with your bumper lift kit? TIA

Mine is on the Blueprint 306

no, the setup I have works with a 1" body lift

yes, 1"

Body Shop sent me this, the hood is on now and seems to clear

I've installed it as pictured above and the body shop has set body on with hood so I think it's good to go, sorry I don't have any pic's of it with body on. Hoping to get it back painted in November

ok, I've ordered front and rear. Goodbye to bumper gap.

You should be able to move the shift rods enough for the gear to to clear the case

I ended up with the Spectre https://www.summitracing.com/parts/SPE-751 with a K&N Filter

I too have the BP 306 w/ pro flow 4 and read on Edelbrock's Forum that the gear that comes on the PF 4 dizzy will work. Now I'm confused. https://forums.edelbrock.com/forum/pro-flo-efi/pro-flo-4/26707-pro-flo-4-distributor-gear

I reached out to him on Feb. 25th, we fine tuned the dash through multiple emails and I received the dash on May, 3rd. It may have been a few weeks between emails but he always responded eventually. I think he does this as a side gig and has a full time job. I am very happy with the end result...

I went through the same thing trying to find a dash I could put AC vents in and get rid of the ashtray & speaker. Also moved the glovebox over. Check with https://www.doubledfab.com He doesn't list Early Broncos on his website but he will make them. He made me this custom one and was...

I've acually been looking at the Spectre as an option. Thanks , I'll take a look at the Triangle one. Lol, Thanks I may end up going the stock route. I have, I'm also going with a 1" body lift to help with clearance for the air cleaner & 4R70W Yes, they are somewhat bulky. Thanks, I...