Recent content by Remos69

So I think I'm going with the Holley 12-289-11 fuel pump, it seems to be in the range for both the qjet and the motor. I could use some recommendations on a fuel regulator, prefer US made and it needs a return.

So I pulled the trigger after talking to him for about an hour. Should have my new to me qjet in a few weeks. Bruce is a wealth of knowledge and a very patient man while I'm sitting in my engine bay describing my setup while also on my tablet giving him my engine specs.

I've got a little over 3000 miles on the FiTech, I replaced 1st 10micron filter after the first injector fail at 500 miles, after the 2nd & 3rd 2500 miles I put in a 30 micron pre and 10 micron in front. I use 93 octane marine ethanol free fuel religiously.

I have a slightly modified 351w, 300hp and torque ~350 atk crate motor. I have a fitech tbi fuel injecton sitting on top. I have replaced 3 injectors in the last 3 years, all stuck open. It looks like I'm going on my 4th. I wanted more reliability, response, and bit modern, but...........I...

https://www.treasury.gov/auctions/irs/fpal_hous_9992.htm 110 6th St. SE, Fort Payne, AL 35967 Would not have posted if it was closer 😜

I'm in!

I used these Set of 2 Split Collar Tube Clamps 2" I.D. https://a.co/d/5spVten to create my shoulder belt, you could do the same and welded on the bar. Below was my fix for my belt. I welded a heim bung for threads and powder coated it to match.

I trimmed mine, but the bronco is in Florida and I'm in NY nursing my daughter post ACL surgery. I'll be back in a week and can take photos. Message me also so I can attempt to remember

I spy with my little eye about 20 seconds in!

Early 2000 BMW power seats

32s

I like mine!

Don't laugh, but black flex seal spray has a similar texture as the floor. Used it to repair a tear on my 2006 f250 floor. Is the guy that ultimately bought my truck a couple years later did not even know it was repaired until I told him

Looks pebble beach beige to me!

I was thinking of just stopping by for a day on Thursday to pick up some parts. It would be on my way to fishing camp in Virginia. I will be without the bronco as I expect it to be packed.