Recent content by snipes243

Messed with it a little more the Fuel pump is grounded out even with the PCM unhooked it runs. I'm thinking something in the Ron Francis Bread board isn't wired correctly. So thats next on the list to dive into.

I’m currently working on a rebuilt 302 engine that has been converted to Explorer EFI. At this point, the engine cranks but will not start. Initially, we experienced some popping from the headers. We began troubleshooting by checking the cam position sensor (cam synchronizer), suspecting it may...

Does anyone have a early bronco steering box that is ported for Hydro assist for sale?

It was intact. Its crazy cause when it popped it sounded like a fail ujoint not the diff grenading

The more I think about it I believe you had a fatigue crack on the third member either on the pinion support needing surface or in the case itself. If it was the pinion guard I would expect to see some elongation on the bolts, but they looked normal. Overall it’s an almost 50 year old case...

I pulled out my spare spiral rings for 30 spline hubs. They measure ~1.370" for a brand new one and ~1.460" for a used ring. Unfortunately the bag is bit old and I can't read the part number on it . One of these should work, but I would measure the diameter of the groove and go off that to be...

Does anyone have a picture of the psc/toms steering box installed? Like a picture from the engine bay looking down at the top of the steering box. I’m mainly looking to see where the ram assist ports pop out.

Now if it could output .stl so you could actually 3d print it.

I'm looking for a kmc machete 17" bead lock 5x5.5"

Looking for a passenger side James duff long arm. I broke mine :)

Sounds good, thanks for the help.

I'm getting ready to install the wild horses quarter armor and I was wondering how everyone attached the soft top lower rails. I wasn't sure if people shimmed up the rails to match the height of the corner guards or cut the corner guards around the soft top rails? any help or pictures will be...

I actually have a 1ton Bronco that I have been working on for last couple of years currently but currently is a 2 seater, its been a supper slow build since I travel for work and little girl. So i was hoping to skip the build process and get it out wheeling :). Last year there was hand full of...

Does this harness come with a wiring diagram of the harness? That was the biggest issue with the centech harness.

Broke out the 3d printer to try out some brackets for the PS res. The p pump bracket for the explorer serp doesn’t give you a lot of option with it being so high up to keep the res above the pump. I’m hoping once I narrow the proflow hood it will cover most of the res, but it will probably...