Recent content by txhawkeye

What is the consensus for the best seals for the early Bronco? I have a 66 that I restored about 4 years ago, I don’t recall where I purchased the seal kit, but they stick and tear away with the door after sitting between use. It may be a bad install on my part but I am looking to order new ones...

I have the same works great, I ordered directly from vintage air though. I am in San Antonio a few times a month so picked it up directly from them. Sent from my iPhone using Tapatalk

I have that set up on mine and it fit fine Sent from my iPhone using Tapatalk

I have a heat sink cooler mounted as shown. It has worked well, I have a 4R70W and had the same overheating issues, the location I used may not work if going off road but this one is my daughters and doesn’t go off road as far as I know. Sent from my iPhone using Tapatalk

I mounted mine on the inside firewall. But had some issues upfront and needed better access to it, so it ended up on the trans tunnel for now. I am building a console and going to build it into that. I would keep it accessible. Sent from my iPhone using Tapatalk

I bought one from Transmission Depot. I was pretty hesitant but it was a good transaction and has worked well so far, I have about 1000 miles on it. I had couple of questions when ordering the trans controller and they had me talk to the guy that built the transmission everyone I dealt with...

Mine progressively got worse at first it was intermittent and then ran poorly all the time, when it was running bad I took the air cleaner off and took a video with my phone and could easily see one of the injectors was not firing. I called the tech line several times, I at first thought it was...

I just went though some issues with my sniper, I had the same type of symptoms including high Air fuel ratio readings I have a 2 barrel and it ended up being that one of the injector rings was going bad. I only had 800 miles on it at the time. Sent from my iPhone using Tapatalk

Thank you! Sent from my iPhone using Tapatalk

Thank you! Sent from my iPhone using Tapatalk

Thank you one of the things I can’t find... Does anyone know what size and thread that but needs to be? Also does anyone know what the taper is on the tie rod I need to buy a reamer but not sure what size I need? Almost there though! Sent from my iPhone using Tapatalk

Thank you for the information I will check the powder coating hopefully that could be the issue. Below is the tie rod and drag link I am installing, l will make the adjustments before they align it I appreciate you catching that for me. Sent from my iPhone using Tapatalk

Can it be reamed out? Sent from my iPhone using Tapatalk

I have the wild horses adjustable tie rod and the stock 66 drag link, I was buttoning it up to get it aligned tomorrow and I stripped the castle nut trying to attach the tie rod to the pitman arm. I thought it should draw up with the nut.. does it need to be pressed in or am I doing something...

Thank you going to try and run the lines tomorrow just wanted to make sure it was right. Sent from my iPhone using Tapatalk