Search results

Still working on brakes:-[

Changed the oil and fluids. Need to bleed the brakes but have to order some new bleeders. P/O rounded them off.

installed a new bulb in the dome light. Still no lights, must be the wiring.

Original color is Vista orange. Trying to decide whether to repaint it the same color or change.

Does anybody have any experience with this roof rack? http://www.4wheelsupply.com/cat.cgi?s=Ford+Bronco(Early)&c=R I'm looking to add a roof rack and came across this one. Any suggestions on others would be appreciated.

Is there any way to determine whether it's a 302 or 351 form these numbers?

I have seen where people were able to decode there engine by the cast numbers on the block. None of the old links worked so I was wondering if someone could help me out. I am trying to figure out what I have. D4DE-8015-AA

It's got spark. I'll check compression.

I pulled the spark plug wire from the distributor one at a time, and each time it would pull on the engine, until I got to number 8. It did not pull on the engine at all. Could the mean this cylinder is dead?

another vote for the tuffy.

I went out for a cruise in my Bronco the other day, ran it about 20 miles or so around town with no problems. I stopped at a gas station, and put some gas in it. Just about the time I got home the engine started starving for gas. I gave it a little gas, and got it to the driveway. While I...

Thanks, I got it. The only problem I ran into was the notch on the new switch seemed to be upside down, so the wiring was very tight to get it back in. The new switch is in, and my interior lights are working along with the speedo cluster. The old one was sparking as I turned the knob. Still...

I have a new light switch to install, but I can't get the old one out. I have the knob and wiring removed, but can't get the old switch out. It looks like there is a retainer that has to be screwed of from the dash side, but the slot is a little too wide for a regular screw driver. What can...

Sounds like fun. Hope I can make it.

Has anyone drilled a hole for a drain plug in their floorboard? Where did you drill, and what did you use for a plug?