Search results

Ok cool thanks!!

I narrowed a dana 44 from a 78 bronco. I used a protractor from homedepot the one with a swinging needle. Well I'm finishing and I just got a digital protractor for an other build I'm doing so I checked my caster basically seeing if each side is the same nope there are off by one degree to each...

sounds good. i'm just trying to figure out if it needs to be perfectly straight. yeah there was some questionable work done on this axles and there were things not done right. it might have been broken when i got it but kinda think i did it trying to get the cast piece off and on. I was beating...

I find it hard to believe that no one knows if this is an issue. come guys.

Someone has to know

rossette welds broken and tube wobles Dana 44 Ok so i,m in the middle of narrowing a 78 bronco dana 44. I don't believe the welds were broken till i started pounding. it was a pain in the but to get the casting end off even with heat. i ended up damaging the mount for track bar really bad. had...

dude sweet!!!!!!!!!!!!!!!!!!!!!!!!

I feel robbed. That is one sweet bronco. I need i full body shot. nice bumper to!

Yeah I wierd I like clean lines so if anything I would weld the piece back in but backwards.

Yeah think I going to just leave it. I'm trying to build a clean rig but not a show rig.

problem solved

think i might just cut the fender well and call it a day

What why? Going long travel suspension I need it.

Tried that stuff knuckle still hits not much but does push the fenderwell in.

the other side already has new 3m under body coating on it all thought i have more of it. possible i think about it. but will wait till i get shock hoops to make sure there is no issues

ok so i did a 4x4x2 conversion. i added 1/4 plate to both sides and .120 wall dom in middle. my knuckle is hitting the fender well. A. I can cut off the 1/4 plate on outside. (probably over kill anyways) B. find a smaller knuckle I rather do B but A will work to. What would you do

looks nice!

Ok got it

Lol Ive seen my friend weld some big gaps but is it needed in my situation? I figure just trimming a bit off bottom Will do just fine.

Yep just made one for the inside too. What do you mean you boxed the inside?