Search results

Saw these online. Got them both for $15 each!

A few pics of my favorites. Lots to choose from!!

Check out this post.... https://classicbroncos.com/forums/threads/what-have-you-done-to-your-bronco-today.146837/post-3507440 I ended up putting on a Bestop bikini and put the heim joints under the windshield frame lip instead on top to make room for the channel bracket.

Any tips from people that have gone before? I am in the planning phase now and have secured my registration! Curious if there are any suggestions or tips on planning, packing, etc....from the members here that have attended in the past. Thanks in advance for any advice!!

Please share pics when installed and how they fit! I’m debating some (the tan 1973 mat) for mine as well.

Picked up at TSC this week in South Florida!!

Found at my local Home Depot in South Florida. Get them while they last!!

Finally got the Bestop Bikini installed! Very pleased!!

Powder coated mine satin black. Would match your interior very well. In my opinion, the powder coating is more durable. And welcome to the EB club!

The wire pictured above broke off from the elbow connector on my intake. Tracing it back, it goes to a wire that connects to the MSD Blaster 2 coil. Not the red or black, but a third wire bundle (not sure of the color) that appears to go from the coil to a clip up near the firewall. Picture...

Added some support to the windshield with some threaded rod braces from BC Broncos. Used some tube clamps with rubber inserts I found online to protect the roll bar finish from the clamp. I think it turned out well and definitely helps with stabilizing the windshield.

Roll bar powder coated and installed. Added some Head Banger roll bar pads from WH.

This half cab beauty was seen at a rum factory in the Dominican Republic!

Took the top off for the first time. So cool to see the Ranger panels stamped with a late ‘72 stamp. Roll bar and soft top install up next!

No thank you....I will keep the gas guzzler!

This is what I did for my 73. Custom Autosound speakers mounted under the rear seat. I ran the wires under the floor mat to the Retrosound unit in my dash. I also replaced the dash speaker with one from Retrosound. IMO, it is a clean look without having to cut side panels or drill holes in...

Well done sir! New interior looks great!!!