SnwMnkys
Sr. Member
Selling my 67 Ford Early Bronco Project. Needs work, but is a good project for someone whos always wanted one of these. Have the title for it. I can deliver it most anywhere within an hours drive.
Has rust in most of the typical spots. Driver side door post is solid, but the passenger side will need to be replaced. Quarter panels, and rear tail light housings were already cut out when I got it. I dont have any replacement sheet metal for it. Doors and fenders are in great shape. Bed is solid. Best to come check it out in person.
I dont have a motor for it. I was going to swap in a 5.0 Explorer motor. So it didnt matter to me if it had one or not. Has a 3 speed manual transmission and the Dana 20 transfer case Ford 9"/Dana 30 axles.. Has all 3 seats, Roll bar, rear gas tank, radiator. Good straight frame. Aftermarket suspension with maybe 2.5" of lift.
Has rust in most of the typical spots. Driver side door post is solid, but the passenger side will need to be replaced. Quarter panels, and rear tail light housings were already cut out when I got it. I dont have any replacement sheet metal for it. Doors and fenders are in great shape. Bed is solid. Best to come check it out in person.
I dont have a motor for it. I was going to swap in a 5.0 Explorer motor. So it didnt matter to me if it had one or not. Has a 3 speed manual transmission and the Dana 20 transfer case Ford 9"/Dana 30 axles.. Has all 3 seats, Roll bar, rear gas tank, radiator. Good straight frame. Aftermarket suspension with maybe 2.5" of lift.
