• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

351W non-EFI fuel pump question

mrbronco

Full Member
Joined
Jul 20, 2002
Messages
308
Loc.
Lufkin,TX.
I am in the process of installing a 351W from a 83 bronco into my 74. The motor came from a truck that had an electric aftermarket fuel pump and a block-off plate on the timing cover where the mechanical pump went. I was going to put the mechanical pump back on it but when i looked in the hole there is nothing to drive the pump. Is there something missing that drives the pump or am i just stupid and don't know what i'm looking at? If i remember right the pump on my old 302 ran off the cam. Do i just need to use the electric pump?
 

Tenacious-B

Jr. Member
Joined
Jan 31, 2007
Messages
87
Loc.
Laguna Hills, CA
The pump should have a long arm attached to it that runs off the cam. That's what actuates the pump. If you don't have an electric pump setup on your Bronco already then it's probably easiest to stick with the mechanical one.
 
Last edited:

saxman

Sr. Member
Joined
Mar 12, 2004
Messages
434
Loc.
Austin, TX
if there is a long arm attached to the pump, make sure to put some white grease before you screw the pump in and fire it up. also, if the offset cam does not allow the fuel pump to be inserted all thh way, turn the engine a quarter turn and it should fit right in.
 

broncnaz

Bronco Guru
Joined
May 22, 2003
Messages
24,342
I'd just go with a electric. I run a carter P4070 they are excellant pumps had one on for 25+ years without a problem.
 
OP
OP
M

mrbronco

Full Member
Joined
Jul 20, 2002
Messages
308
Loc.
Lufkin,TX.
I stuck the mechanical pump in the hole and it went in just fine. I forgot to mention the motor is out of the truck right now. Anyway,it didn't "hit" anything when i stuck it in. Like it would if it bumped the cam. And when i looked through the hole with a flashlight there didn't appear anything inside that would work the arm of the pump. And it is a long arm pump.
 
OP
OP
M

mrbronco

Full Member
Joined
Jul 20, 2002
Messages
308
Loc.
Lufkin,TX.
It drives off of a round offset piece mounted to the front of the camshaft on top of the timing gear...

I'll look again and see if that's there. The motor was built with the intention of a electric pump so that may have been left off.
 
Top