BroncoVela
New Member
I am soon replacing two of my quarter panels on my '73. I have heard horror stories of aftermarket panels that don't fit properly. Any recommendations on where to purchase them from..Thanks
Community
Buy / Sell
Bronco Tech
Fuel Tank Access Plate
3 Arm Wiper Setup
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
3 Arm Wiper Setup
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
-
Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!If you have problems registering or can't log into your account, please contact Admin.
Best Quarter panels on the market
- Thread starter BroncoVela
- Start date
broncorick
Sr. Member
- Joined
- Oct 16, 2004
- Messages
- 967
As far as I have seen there is a single manufacturer for these. The look good but do require fitting. Better as a patch panel than complete replacement. Last one I did, i fit the panel int the place of the old one which I entirely removed. The clecoed into place olong the top edgr, the fit to the rear tailight section as this has the most bow to it. I adjusted the bow by making kerf cuts in the edge so I could bend it without distorting the metal. Once that was clecoed in, I fit it to the striker post which entailed more kerf cuts and having to rebend the lio to make it fit (was originally too long). It now looks good. I have some finishing to to, But bowing is correct.
