Biggest tires you can fit on a 67 with uncut fenders

[Bigblackbronco]

I have a 1967 with a 3 inch lift the front fenders are uncut but the rear ones are cut. I'm trying to find out what the biggest tires are that you can put on an uncut bronco without it rubbing while riding off-road? I put some 33s on her and they fit fine and I'm pretty sure I would be safe riding around with them on but I'm afraid they will rub of I make a sharp turn or take them off-road?? I'd really appreciate any incite thanks!!

 

[nickgp]

The 33s will rub the front fenders when the suspension articulates. 31s might be a bit better.

 

[Terkish]

you shouldn't have to trim much on the front to keep the 33's from touching with the 3 in lift.

http://www.youtube.com/watch?v=UFryCoV1Eac

I was able to trim just the front little corner on the bronco in my avatar picture and cleared 33's on a uncut front fenders and a 2in lift.

 

[Bigblackbronco]

Hey Terkish thanks think you could post a picture of those frount tire on you bronco so I could see how it looks thanks again

 

[Terkish]

These are before and after paint. The corner that is cut off is on the front part of the front fender kind of up where it curves under. You can't even really see it. I didn't cut the rear myself the PO did it. It wasn't the cleanest. I don't have this bronco any more so this is the best pictures I could find with the 33x12.50's. Hope it helps.

 

[Explorer]

Width play's a factor. 10.50's I haven't had a problem. 12.50's are another story. They rub both the front fender and control arms when turned sharply.

 

[needabronco]

I have a bone stock uncut 66' half cab with 265/75/16's that were installed prior to me getting it, it surprisingly only rubs slightly on the front fenders and radius arms.