Body lift (old bolt removal)

[Schreiber]

Several years ago when the Bronco got a face-lift, new floor pans were fabricated OVER the old floor pans. Now, as I'm trying to remove the old body mount bolts, I realize I can't access these bolts under my driver and passenger floor pans. I think I can remove the pans by removing the pop rivets that are holding them there; is there an easier route to removing the pans and installing my body lift?

 

[Izzy]

JUst us a hole cutting bit and cut a 2 " hole where the bolt is. You just have to carefully measure where that is.

 

[Schreiber]

JUst us a hole cutting bit and cut a 2 " hole where the bolt is. You just have to carefully measure where that is.

Good idea. I'll have measure real careful if I go that route.

 

[shamu]

Ck out my pics. Both are approx 4" back fron the first bend. Passenger side is 7" from tunnel. Drivers is 11" from tunnell. All measurements are flat.