Bracket for washer fluid and coolant tank

[Concrete]

Hello a few years back Tom’s offered a bracket for the washer fluid/coolant tank. They longer sell it. Does anyone else make this bracket? Thanks

 

[Soylent]

@JSmall was making them here.

 

[davisjstone]

I would love one if someone is still making them.

 

[BronCowie]

You don't need it. Trust me, I used some materials I had stashed away in my shop to fab up stand-offs for this tub so it would clear the fender enough for access to the filler caps. I'll try and find some pics, but my bronco is not handy at the moment, stored in my daughter's garage about 10 miles away. FYI, JSmall does not frequent this site much if any anymore. He has moved on to other ventures involving jeeps from what I've heard.

 

[davisjstone]

You don't need it. Trust me, I used some materials I had stashed away in my shop to fab up stand-offs for this tub so it would clear the fender enough for access to the filler caps. I'll try and find some pics, but my bronco is not handy at the moment, stored in my daughter's garage about 10 miles away. FYI, JSmall does not frequent this site much if any anymore. He has moved on to other ventures involving jeeps from what I've heard.

Good to know. Pics would be great. I’m just about at the point of installing my new tank and any pointers is appreciated.

 

[BronCowie]

I'll be going over to my daughter's house in a week or two. I can take a close look at what I did and take pics then if you still want them.

 

[Oldtimer]

Take a look at this thread:

Radiator Puke Tank

I have a stock replacement radiator overflow tank but was looking for some other options. What are you guys using if not a stock setup? Pros and cons if any with your setup? Thanks

classicbroncos.com

 

[BronCowie]

Take a look at this thread:

Radiator Puke Tank

I have a stock replacement radiator overflow tank but was looking for some other options. What are you guys using if not a stock setup? Pros and cons if any with your setup? Thanks

classicbroncos.com

Post #5 in this thread is a pic of my installation. If I recall I simply placed a large nut between the tank and fender to get it to standoff ~1/2" so the filler caps cleared the fender to open them.