Bronco plaque or clock, it's widget time again.

[doghows72]

So if you guys remember I did a key chain thing a while back. Well my friend and I have been at it again. We are thinking of making this cut out for either a wall plaque or in clock form. Approximate size will be 12" tall by 16" long. Should have the prototype done Monday after turkeyday.
So is there any interest in owning one of these? We are probably at a price point of$40-$50 and I think I can make them fit into a flat rate box so shipping should only be like $10.
I'll post up the prototype when it's done but in the mean time here is what we have so far.
One will be uncut half cab and the other will be uncut full cab. There is a possibility of doing an exact one from a photo of your own rig as well but that would be a bit more expensive due to all the computer work needed.
If there is enough interest I will move this to the vendor mass buy area to abide by Jons forum rules. Thanks Steve.

 

[Major Tom]

like these

 

[doghows72]

No these will be a cut out of the bronco in the picture out of 10 guage steel. If I do clocks there will be a dial in the center of the bronco. No cheap plastic. More like a giant version of the key fob I did last year.

 

[o2bnmud]

So something like this, except as a clock.

http://www.bcmetalart.com/~bcmetala/