- Joined
- Sep 26, 2011
- Messages
- 21
Custom 69 classic Ford Bronco Pre Runner / Rock Crawler as seen in OFFROAD MAGAZINE. This car has to much custom stuff done to it to list. Here is a list of some custom parts and what has been done.
-West Coast Broncos front and rear prerunner fiberglass fenders
-Fiberglass hood
-Custom rollcage tied to frame at 6 points
-Frame and suspension components powdercoated
-Custom engine cage for King coil over shocks
-Custom rear shock hoops with Kings
-Custom Deaver rear springs
-3 New Beard Ultra race seats with 5 point harnesses
-351w 450hp, aluminum heads, JE pistons, Edelbrock Air gap intake, Holley carb and MSD ignition
-Complete exhaust system ceramic coated
-C6 trans with no miles full built
-Winters shifter
-Custom aluminum fuel tank
-Dana 20 transfer case with twin stick shifters
-Dana 44 front with F150 disc brakes and Detroit locker
-Currie F9 Fabricated axle with 35 spline shafts, Detroit locker and Wilwood disk brakes
-6 Brand new BFG 37x12.5x17 mud terrain KM2 mounted on Raceline Monster Bead Locks(real beadlocks not fake)
-54" LED light bar
-9000 lb Ramsey winch
All this bronco needs is to be completed (wiring, hang rear fenders,pair of front shocks, fuel pump / lines and bodywork) It would take countless hours and money to get another bronco to this point You can reach me at 9four9244five337 I may be interested in trade / trading / trades such as a class A diesel pusher motor home / RV. Yes the Bronco has a clean title and can be registered for the street.
-West Coast Broncos front and rear prerunner fiberglass fenders
-Fiberglass hood
-Custom rollcage tied to frame at 6 points
-Frame and suspension components powdercoated
-Custom engine cage for King coil over shocks
-Custom rear shock hoops with Kings
-Custom Deaver rear springs
-3 New Beard Ultra race seats with 5 point harnesses
-351w 450hp, aluminum heads, JE pistons, Edelbrock Air gap intake, Holley carb and MSD ignition
-Complete exhaust system ceramic coated
-C6 trans with no miles full built
-Winters shifter
-Custom aluminum fuel tank
-Dana 20 transfer case with twin stick shifters
-Dana 44 front with F150 disc brakes and Detroit locker
-Currie F9 Fabricated axle with 35 spline shafts, Detroit locker and Wilwood disk brakes
-6 Brand new BFG 37x12.5x17 mud terrain KM2 mounted on Raceline Monster Bead Locks(real beadlocks not fake)
-54" LED light bar
-9000 lb Ramsey winch
All this bronco needs is to be completed (wiring, hang rear fenders,pair of front shocks, fuel pump / lines and bodywork) It would take countless hours and money to get another bronco to this point You can reach me at 9four9244five337 I may be interested in trade / trading / trades such as a class A diesel pusher motor home / RV. Yes the Bronco has a clean title and can be registered for the street.
Last edited: