Floor Pan Help

[jdrambo]

I need pics of the body mounts that are on the drivers and passenger side pans. The reason being i just was cutting out the rusted floors and noticed no nut or bolt any where until I had all the floor out. the body mount was only attached to the floor support.

so I am going to guess the floors i just cut out were the second set and instead of making the floors correctly he just bolted the body mount back down under the floors... please enlighten me so i can build my new floors correctly

thanks you guys rule!

 

[jdrambo]

seriously no one knows anything about the front body mounts???

 

[ugly74]

I have a couple of pics in my gallery of patches I made for my floors up front. no pics from underneath though...

 

[jdrambo]

I have a couple of pics in my gallery of patches I made for my floors up front. no pics from underneath though...

you had exactly what i needed. thanks ugly74. i just need to now figure out how to make the dimple

 

[tobinj]

you had exactly what i needed. thanks ugly74. i just need to now figure out how to make the dimple

'''''It's a 1 1/4" socket, a 3/4" socket, a washer, a ball joint sleeve, a washer all put on a long bolt. You stack it up on your pan where the body mount hole is, MAKE SURE THE SMALLER (3/4") SOCKET IS ON THE TOP SIDE. When it's all together you heat the top side with your torch and when its red around the small socket tighten the bolt till you have a dimple big enough to recess the body bolt and washer. It only takes a few minutes and works great.'''''

I took this from bronco fix looks simple enough