Community
Message Forum
Photo Gallery
Event Calendar
Book Reviews
Bronco Wallpaper
Bronco FAQ
Link Back to CB!
Photo Gallery
Event Calendar
Book Reviews
Bronco Wallpaper
Bronco FAQ
Link Back to CB!
Buy / Sell
Bronco Tech
3 Arm Wiper Setup
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
-
Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!If you have problems registering or can't log into your account, please contact Admin.
Ford Part Number for Smaller than Stock Water Pump Pulley
- Thread starter Mikey
- Start date
There was at least one made for the older 289's. Same offset for the FE's too. I had one a few years back but don't recall the numbers on it. If I'm not mistaken the aftermarket chrome pulleys were the same, Summit used to list em in their catalog but I don't see them now.
I searched the wrecking Yards over and found a smaller 2 grove off a Jeep. Now I can't say that I didn't drill new bolt hole in mine... AKA Put a 2d set of holes in it.
It still did not fix my overheating.
It still did not fix my overheating.
