fuel rail crossover lines explorer

[nkhd1]

about to install 97 explorer fuel rail and removed one of the crossover lines figuring they should be replaced. what is the best way to replace the lines?

I have seen mention on internet of using high pressure efi hose and clamps.
Is this the way to go?

Thanks

 

[Green_Bastard]

As long as you’re u use EFI specific hose and clamps you should be good.


Sent from my iPhone using Tapatalk

 

[EricLar80]

I did it and it seems to work just fine. I have read that the nylon line can be used on the barb as well. Be careful when removing the line so as to not damage the barb fitting.