jn2630
Full Member
Has anyone made their own soft doors for door inserts?
Community
Message Forum
Photo Gallery
Event Calendar
Book Reviews
Bronco Wallpaper
Bronco FAQ
Link Back to CB!
Photo Gallery
Event Calendar
Book Reviews
Bronco Wallpaper
Bronco FAQ
Link Back to CB!
Buy / Sell
Bronco Tech
3 Arm Wiper Setup
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
-
Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!If you have problems registering or can't log into your account, please contact Admin.
home built soft doors. has it been done?
- Thread starter jn2630
- Start date
Yeah, I made my own door insert doors. The lower half has a steel frame that has a HDPE plastic skin. The removalble window section has an aluminum frame with sliding lexan windows. I just reskinned and rewindowed the doors after 10 yrs of daily driving.
Not quite "soft" doors but highly durable sealed doors.
Not quite "soft" doors but highly durable sealed doors.
OP
OP
jn2630
Full Member
sweet! can you post a pic of this? I think I want to make my own and need some ideas
Daddy4zack
Sr. Member
Yes please pics...
tatersalad
Bronco Guru
- Joined
- Jan 17, 2009
- Messages
- 1,067
I wish one of the vendors would make a door insert with about a 3/4 inch lip that starts at the same spot as where the windshield meets so that a seal could be attached and the soft door would seal against it. if i was good with glass i would just add it to mine and then my best top doors would actually seal good.
