Inner rear quarter panel alignment

[302fix]

I'm trying to line up my rear inner quarter panel.
It's sticking out quite a bit at the top.
Do I have it in there right? Any thoughts?

 

[Revelation]

If it is sitting flush on the floors and wheel wells you might have to do some trimming of the top lip. Cant tell from the pics but do they match the profile of stock?

 

[302fix]

I have a good mating surface from the floors and wheel wells. It's just the top sticking out which I was going to trim but was just checking first.

I'll probably screw in the outer quarter and mark where I'll cut the top of the inner first.