Measurement needed for rear reflectors - 1971

[904Bronco]

I have run a couple of searches without luck...

Does anyone have the measurement for where the rear red reflectors are mounted below the tail lights?

I do not have a rear tire carrier.

Thanks in advance. Doug

 

[hankjr]

I can get you a pic in a couple hours. I don't have the reflector installed, and only have drivers side holes, but it's a start for you
Hank

 

[hankjr]

I got some pics. PM me a phone I can text to or an email. I can't post via Tapatalk. Can't seem to be able to get unlimited photo posting

Hank

 

[904Bronco]

Sent U a PM. Thanks again.

 

[NC_Pinz]

Here is a pic from a 75 with the reflectors in their factory spots. Let me know if you need exact measurements. Note the one on the passenger side has a bracket attached to it while the driver's side does not.

 

[904Bronco]

Thanks for the pictures Hank.

So I transferred the measurement for the holes and this is what I have...

Then I decided to look at other Bronco pictures (Ebay, Google) Probably a mistake, but I see slight differences.

I am probably being too AR about this, but once you drill the holes it stays there.

I am looking for a picture(s) of the Drvrs side mounted just to compare. I don't have a tire rack so I will do the same on the Pass side.

 

[BRONKEN]

I can measure when I get home or you can stop by and look at the 76.