need body mount dimensions. Please!

[nsdq3]

Finally got the floor out and my two body mounts under the driver and passenger floor pans are royally screwed. Could someone please give me the distance from the small hole on the mounts to the center of the large hole, where the bushing goes. I can weld in new metal but I need to know where to center it up at. I'm assuming the center of the two holes are in line, please let me know if that is a bad assumption.

Thanks, Doug

 

[halfcab1969]

Found this hope it helps http://classicbroncos.com/forums/attachment.php?attachmentid=80939&d=1194838325

 

[halfcab1969]

Wait this one's better http://classicbroncos.com/forums/attachment.php?attachmentid=244173&d=1329530702

 

[wsager]

http://www.supermotors.net/registry/media/876772

This is to scale, so you can measure with a photo editor. See the caption.

 

[nsdq3]

OK, first and foremost, thanks to all. I am pretty tech stupid so how do I equate that last link from wsager to actual dimensions. I have never used photo editor.

 

[bronkenn]

Just measured mine: The hole is 1- 7/16 diameter; from the outside edge of small hole to inside edge of body mount hole is 2- 1/2; center to center of holes are 3- 9/16. The body mount holes are centered on the bracket front to rear. Ken

 

[nsdq3]

Just measured mine: The hole is 1- 3/16 diameter; from the outside edge of small hole to inside edge of body mount hole is 2- 1/2; center to center of holes are 3- 9/16. The body mount holes are centered on the bracket front to rear. Ken

Thank you Sir!