new master cylinder installed; did i plumb it right?

[taz7nads]

i got my new master cylinder installed yesterday, capping off a complete re-work of the brake system. the original lines from the m/c to the h-block were gone, so i want to make sure i've got the new ones routed correctly. the line from the rear (large) reservoir is going to the passenger side of the h-block, and then it looks like (looking down from the top) it is going to the front brakes. the line from the front (small) reservoir is going to the driver's side of the h-block; it appears to then go to the rear. is this correct?

 

[hyghlndr]

The lines from the Big Bowl go to the front brakes, and the small Reservoir goes to the rear brakes..

 

[taz7nads]

Okay, thanks. That's what I thought; will crawl under tomorrow and make sure the lines out of the h block go where I think they do

 

[agboy91]

so what would happen if the routing was opposite, big bowl to rear?

 

[hyghlndr]

It might not move enough fluid for the front brakes, it would effect braking.

 

[Slednut10]

so what would happen if the routing was opposite, big bowl to rear?

This thread answers that question
http://classicbroncos.com/forums/showthread.php?t=278136&highlight=Master+cylinder