SD Original Steel Halfcab Top

[greatguy57078]

I am selling a very nice original steel halfcab off a 1968 Bronco. This was on a plow truck up in northern MN. It has a few small repairable dents and very little surface rust. I am sure that any guy with body work experience could fix it right up. The rust in the corners where it bolts to the windshield are the only areas that have pits in them, but you can see in the pics that it is not that bad at all. I have tried my very best to show you everything I can in the pics posted. Feel free to ask me any questions about the condition of this item. I do not think this was ever removed off the truck, until I did so myself.

The original seal was on the front until I removed it to make sure that there were no rusted areas underneath. It had all the original seals on it, and you can even see the original paint from 1968 in one of the pics. I used a wire brush wheel and a drill to clean up the drip rails after I removed the seam sealer. As you can see in the pics it is shiny metal and shows all the spot welds.

I would keep this for my own use, but I have another one that I am cleaning up and it looks to be in great shape also. I have quite a few pics that I will post here in a few. I am pretty firm on the $750, as I have sold a few of these in the past and they always sell, sooner or later.
Please feel free to email me and ask any questions.

Thank you for your interest.
Marty
greatguy57078@yahoo.com

 

[greatguy57078]

A few more pics...

 

[greatguy57078]

and a few more....these show the small dents and the minor rust in the corners.

 

[greatguy57078]

These pics show the original seal which was still on the top until I removed it (can be reattached). The windshield frame is still in good condition, especially where the top and windshield were attached. The original paint is still shiny. Where the bulkhead and top attached was also new looking. Unfortunately the bottom of the bulkhead on the drivers side was badly rusted at the bottom.

 

[greatguy57078]

Let me know if you would like pictures of other areas. I would be happy to take a few more. Again, thank you for your interest.

Marty
greatguy57078@yahoo.com

 

[greatguy57078]

I would also like to add that I sanded a couple areas on the cab (can be seen in some of the side pics), and it has just the one layer of paint and one layer or original primer underneath.;D