Roll cage Building - PipeMaster?

[jeffncs]

Thinking about grabbing one of these in 2” od and either 1 1/4” or 1 1/2” depending on tube choice. I’m building 2 cages and figure it won’t hurt…just not cheap. Is it worth it?

https://www.amazon.com/dp/B01AYJOJAI/?tag=classicbroncos-20

 

[jeffncs]

 

[36Fan]

You can get the same results using thick paper, look on youtube for coping and fab tricks. Once you do a few copes you'll get the hang of it. Rough in your cope with a chop saw and fine tune the fit with a 4.5" angle grinder flap disc.

 

[hunter1]

Looks like it would work. I'd be interested in trying one as well.

 

[SteveL]

Don't need em to do basic cages. I bought a couple on sale but haven't used em. Figured they might be good for odd angles.

 

[jeffncs]

Don't need em to do basic cages. I bought a couple on sale but haven't used em. Figured they might be good for odd angles.

Shoot me a PM if you’d be willing to sell or loan them. I’m looking at the 2” tube and a smaller diameter (maybe 1.5”)

 

[Yeller]

They work exceptionally well for notches you cannot measure the angle of and odd intersecting nodes.