Side Marker and Filler Neck Location Dimensions?

[Fur_Pig]

Hey guys,

I'm prepping my new sheetmetal for prime/paint and wanted to cut my holes for side markers and the rear fuel fill. Does anyone know of any pics w/dimensional references I can use for location? Not overly worried about it and "close enough is good enough for my build but want the filler neck to line up properly.

 

[jamesroney]

Hey guys,

I'm prepping my new sheetmetal for prime/paint and wanted to cut my holes for side markers and the rear fuel fill. Does anyone know of any pics w/dimensional references I can use for location? Not overly worried about it and "close enough is good enough for my build but want the filler neck to line up properly.

This is still written on the side of my Bronco. The dimensions reference the to the edges of the hole. Enjoy.
Don’t forget that the mounting holes are square with plastic inserts.

 

[Madgyver]

here are pics of the firebronco

 

[awest5321]

Make sure to get the hole as high as possible. Mine is 3\4 low and my filler neck fills up with gas and leaks around the rubber hose. I will be dropping my Sherman 23 gal tank about an inch to fix this.