• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

stock radio install

ecoleman1

Jr. Member
Joined
Jul 16, 2012
Messages
99
Need help installing stock radio! It is hitting the heater box preventing me from getting it up high enough to fit in the slot. Does the entire heater box have to come out or can you take the inside part off? What does removing the entire heater box involve? Is there an easier way to install the radio? I've never removed a heater box! This is a stock 73 wagon. Help!
 

needabronco

Bronco Guru
Joined
Jul 2, 2004
Messages
6,411
Loc.
Prescott/Farmington
Take a deep breath, drink a beer and relax! It'll fit you've just gotta hold it at the right angle. Try angling the radio up and over the heater box.
 
OP
OP
E

ecoleman1

Jr. Member
Joined
Jul 16, 2012
Messages
99
Thanks for the encouragement Needabronco. The hanging down support that grounds to the lower dash is getting in the way also. I'll try again tomorrow. Any more suggestions out there? I shoulda said I'll cry again tomorrow!!!!!!
 

904Bronco

Contributor
Bronco Guru
Joined
Sep 28, 2004
Messages
6,720
Loc.
San Martin, CA
Can you remove the lower dash support bracket at each kick panel, that will allow the dash to move forward some...
 

d.c.parris

Full Member
Joined
Aug 26, 2005
Messages
168
Loc.
cumming ga.
the stock radio does not have a slot in the dash. there are only 3 small holes in the dash for the stock radio the outside dial is held on with 2 small screws. there is pleanty of room for the stosk radio
 

904Bronco

Contributor
Bronco Guru
Joined
Sep 28, 2004
Messages
6,720
Loc.
San Martin, CA
^^^ That raises the question... Here is a stock dash with the radio holes...

Is this this what you are trying to install a radio in?
 

Attachments

  • DSCN1514.jpg
    DSCN1514.jpg
    94.2 KB · Views: 81
OP
OP
E

ecoleman1

Jr. Member
Joined
Jul 16, 2012
Messages
99
904 my dash had a slot cut out between the two holes by PO, but my radio face covered it perfectly. Anyway, got it in today! Just had to get the right angle and hold my mouth just right. Only one station but it sounds good. Thanks guys
1
 
Top