Tailgate filler panel (between tailgate & bumper)

[Bronco Sport]

Anyone know where I can get a diamond plate tailgate filler panel from? I'm looking for the one that goes between the tailgate and the bumper. I just have the stock body mounts but it look uncomplete without something in there. Is this just something you have to make your self?

Thanks!
Ron

 

[TJK74]

I have never seen one for sale but have seen some custom roll pans made.
Let us know if you find on thats pre made

 

[67ster]

Check with some metal fabrication shops in your area , they may have some remnant aluminum tread brite material laying around . If they have a shear and brake , it wouldn't be much of a task to knock one out for you .

 

[Bronco Sport]

I found a guy that can have a diamond plate roll pan made that will be custom cut to fit the Bronco. It will be 58" x 3.5" (to work with the stock height, without any body lift) with the cut outs for the frame where the stock bumper mounts to the frame. I'd like to know how many people might be interested in a MASS buy on these. He can also have them made a bit wider to accommodate you guy's with body lifts. The price has yet to be determined, but it should be around the $35.00 range. It all depends on the number of people that are interested.



Let me know if you have any questions.

Thanks!
Ron Morris

 

[teqoso]

i'D BE INTERESTED IF HE COULD MAKE IT OUT OF SMOOTH SHEET METAL. tHANKS

 

[airman]

I'm interested in hiding my wires and the ugle top of my rear tank. How does it mount?

Jeff in AZ

 

[Bronco Sport]

I'm interested in hiding my wires and the ugle top of my rear tank. How does it mount?

Jeff in AZ

There is a flat area next to the bottom of the taillights where it is recessed for the tailgate. My thought was that you could just use a couple stainless screws on both sides.

Also I'm going to start a poll to see how many would be interested in a mass buy.

-Ron

 

[Bronco Sport]

If you are interested make sure to reply to
Tailgate roll pan possible MASS buy -POST