Stock lower shaft for a manual or 4x4x2 steering box.
This part originally came on a 76 or 77 Bronco that was ordered with manual steering.
Because the manual steering box uses the same size and spline input shaft as a 4x4x2 box, this can be used with a 4x4x2.
Like all manual steering boxes, this shaft uses the bell coupling and not an actual u-joint.
This has been sitting for quite some time and will most likely need to be heated up, lubed, and persuaded to slide in and out again.
$75 + shipping OBO
This part originally came on a 76 or 77 Bronco that was ordered with manual steering.
Because the manual steering box uses the same size and spline input shaft as a 4x4x2 box, this can be used with a 4x4x2.
Like all manual steering boxes, this shaft uses the bell coupling and not an actual u-joint.
This has been sitting for quite some time and will most likely need to be heated up, lubed, and persuaded to slide in and out again.
$75 + shipping OBO
Attachments
Last edited: