IN Used Driveshafts - Various Lengths/Condition

[Jeff10]

Hi,

I have accumulated some driveshafts. Some I are in good condition, others I'm not sure about. I will list the details that I know and an asking price. Please feel free to ask any questions you might have. (Pictures are from top left to right, then bottom left to right.) Measurements are from outside CV joint to outside u-joint.

Pic 1: 23" Comp / 25-1/2" Ext; Front D/S w/CV; Good running condition from 1971 Bronco w/3-1/2" suspension lift. $100
Pic 2: 31-1/2" Comp / 35" Ext; Rear D/S w/CV; Good running condition from 1971 Bronco w/3-1/2" suspension lift. $100
Pic 3: 24" Comp / 26-1/2 Ext; Front D/S w/CV; Purchased as a spare. Advertised as rebuilt when I purchased it. $100
Pic 4: 23" Comp / 24-1/2 Ext; Front D/S w/CV; Not sure of condition. Purchased with 1972 project Bronco. $50
Pic 5: 34-1/2" Comp / 36-1/2" Ext; Rear D/S w/CV; Not sure of condition. Purchased with 1972 project Bronco. $50
Pic 6: 32-1/2" Comp / 35-1/2" Ext; Rear D/S w/CV; Working driveshaft installed on 1970 Bronco when purchased.. $75
Pic 7: 22-1/2" Comp / 24-1/2" Ext; Front D/S Non-CV; Working driveshaft installed on 1970 Bronco when purchased.. $50

I would be comfortable running the first 3 driveshafts. The last 4 I would have rebuilt and checked for balance if I were going to install them. (A couple of the caps/bearings are missing, too.)

Shipping is additional.

Thanks for looking.

Jeff

 

[Outlaw Bronco]

I could be interested in two of the first three shafts. I will do some measuring and get back to you asap!

Thanks Brandon.

 

[Jeff10]

Hi Brandon,

I could be interested in two of the first three shafts. I will do some measuring and get back to you asap!

Thanks Brandon.

Thanks,

Jeff

 

[Bronco73]

I will measure my front and see if one of these will fit.

 

[Outlaw Bronco]

Hi Brandon,



Thanks,

Jeff

No luck for me on these's! Bump for ya.

Thanks Brandon.

 

[Jeff10]

Hi,

All of the driveshafts are still available.

Thanks,

Jeff

 

[Bronco73]

I keep forgetting to measure mine. I will try to remember tomorrow when I am back out in the garage working.

 

[Jeff10]

Hi,

Bump for the weekend.

I'm going to hold back the two driveshafts in pics 1 and 2 until I know if I will be reusing the Dana 20 with Terelow gears also listed for sale here on CB.

Thanks,

Jeff