Windshield washer squirter hole locations?

[langester]

I have a fiberglass hood that I need to drill the squirter holes for the windshield washer fluid. I do not have a stock hood to check out, so I am hoping someone can help me out. Does anyone have the measurements for these handy by chance?

As always "Thanks in advance"!

 

[1strodeo]

I measure, from the driver side of hood, 1st hole center is 16 7/16, second hole center is 34 1/2, both centers 7” from back edge of hood -Jeff

 

[1strodeo]

Hole is 5/16 by the way ;D

 

[langester]

Thank you! I appreciate it!

 

[74 Bronco Billy]

This site just rocks, every day.

Sent from my SAMSUNG-SM-G930A using Tapatalk

 

[langester]

Yes it does! I have not been disappointed yet when asking a question. Everyone is always willing to help. I would not be where I am at with my build without this site. Thanks to everyone here!

 

[1strodeo]

This site just rocks, every day.

Sent from my SAMSUNG-SM-G930A using Tapatalk

Yes it does! I have not been disappointed yet when asking a question. Everyone is always willing to help. I would not be where I am at with my build without this site. Thanks to everyone here!

As a matter of fact, the yellow hood in the photos belongs to another member tpatton75 who let me borrow it for fitment purposes

 

[langester]

That's what I am talking about right there! If the world would take note and run like this community does it would be a better place!