Classic Broncos Home
  Classy Gauges     Toms Offroad

   Ford Bronco Parts - Classic Vintage Early Bronco Parts   Toms Bronco Parts   BC Broncos
Community
 Message Forum
 Photo Gallery
 Bronco Garage
 Event Calendar
 Bronco Wallpaper
 Bronco FAQ
 Link Back to CB.com
Buy / Sell
 Classifieds / Want Ads
 Vendor Forum
James Duff
Rust Bullet
Sexton Offroad
Bronco Tech
Recent Tech Articles
  3 Arm Wiper Setup
  Fix Motor Mount
  Roll Cage Braces
  Throttle Body 65mm
  Wheel Alignment
  Heat Riser Replacement
  Vent Window Repair
  Center Console Mount
  Straighten Bumper
  Ford 6R80 6 spd
     More Tech...
Ford Bronco Parts - Classic Vintage Early Bronco Parts

9" Axle Removal
How to pull rear axles on a Ford Bronco.
Tech article by Joe O'Neil (Mr Joe)


Difficulty Level - Easy

Jack up vehicle and place sturdy jack stands under axle. If removing third member, Remove and secure driveshaft, Remove wheels and brake drums.

Axle Removal
Remove 4 retainer nuts located on vacuum plate. (Big bearing socket size is ¾”) Axle Removal
Install brake drum backwards and install lug nuts a couple turns. Axle Removal
Use brake drum as a slide hammer until axle bearing clears housing. Axle Removal
Notice progress. Axle Removal
Remove axle and you're done!

Tech article by Joe O'Neil (Mr Joe)

 Axle Removal


 

This Early Bronco site created and maintained by Jon Hanna - Copyright © 1996- All rights reserved. Privacy Statement
ClassicBroncos.com is not affiliated or associated with Ford Motor Company. Ford Bronco and Ford Bronco logos are property, copyright, trademarks and/or service marks of Ford Motor Company.