firehawk
Sr. Member
I am finally going to share the build of my '71 Bronco.
I bought it off Ebay last summer and had it shipped form Arizona to Michigan.
The previous owner had already put efi on it and hydroboost from a 94 mustang.
Pretty solid, at least from what I had seen here in Michigan. Of course after I bought it I came across several others that I probably would have bought instead. But that is hindsight. I still want to buy the one with a C4 and 351, slighty more solid than mine was and it has the prerunner front bumper I want.
Well back to the condition. The po also replaced the floor pans and it was not up my satisfaction as the welds were too small, 1/4 inch and 90% of them were not attached to the underlying structure, they just filled the hole he had drilled. I did like the extra thickness of the sheet metal he used over
stock but I decided to go ahead and buy the replacement floor pans from JBG. They fit pretty good and all I had to do was cut out the replacements and weld in the new ones along with drivers side kick panel.
I bought it off Ebay last summer and had it shipped form Arizona to Michigan.
The previous owner had already put efi on it and hydroboost from a 94 mustang.
Pretty solid, at least from what I had seen here in Michigan. Of course after I bought it I came across several others that I probably would have bought instead. But that is hindsight. I still want to buy the one with a C4 and 351, slighty more solid than mine was and it has the prerunner front bumper I want.
Well back to the condition. The po also replaced the floor pans and it was not up my satisfaction as the welds were too small, 1/4 inch and 90% of them were not attached to the underlying structure, they just filled the hole he had drilled. I did like the extra thickness of the sheet metal he used over
stock but I decided to go ahead and buy the replacement floor pans from JBG. They fit pretty good and all I had to do was cut out the replacements and weld in the new ones along with drivers side kick panel.