Ignition swirch wiring?

M

mcdobson

Sr. Member

Joined

Jul 28, 2008

Messages

401

Loc.

Sacramento

• Aug 3, 2009

• #1

My 74 has an after market ignition switch in it. I bought an ignition switch door lock combo from BC. I have a wiring diagram that shows the wires that go to the switch but not which terminal they go to.
Any one have a better diagram or can tell me where they go? None of the terminals on the switch are marked.
Thanks.

 

Viperwolf1

Contributor

electron whisperer

Joined

Aug 23, 2007

Messages

24,333

• Aug 3, 2009

• #2

Try these. You might have to use an ohmmeter to figure out which terminals are which but you can see the factory wires colors here.

 

Attachments

• 
  ignition sw 2.jpg

  39.5 KB · Views: 221

OP

OP

M

mcdobson

Sr. Member

Joined

Jul 28, 2008

Messages

401

Loc.

Sacramento

• Aug 3, 2009

• #3

Thanks Viperwolf, I think that is going to do it. Assuming the two loops go around the post and the ground goes to the outside terminal.

 

Viperwolf1

Contributor

electron whisperer

Joined

Aug 23, 2007

Messages

24,333

• Aug 3, 2009

• #4

Yes that is correct.

 

OP

OP

M

mcdobson

Sr. Member

Joined

Jul 28, 2008

Messages

401

Loc.

Sacramento

• Aug 3, 2009

• #5

Thanks much.

 

OP

OP

M

mcdobson

Sr. Member

Joined

Jul 28, 2008

Messages

401

Loc.

Sacramento

• Aug 5, 2009

• #6

New switch in, everything works. I am so happy. Thanks again Viperwolf.
I was a little disappointed in the quality of the bezel, keys and lock cylinder.
On to the door locks.