If you're doing tintable, get several cheap measuring cups. There isn't enough room in the bottle for the hardener and paint to mix in so I found myself mixing in the cup and pouring in.
IT GETS EVERYWHERE. and is sticky. Wear protection and clear areas you don't want overspray on.
Clean the gun between bottles.
Start with the tight/harder to reach spaces. usually don't finish the best as you have to get close.
If possible, stand your items vertical to spray. Makes the job muchhhhh easier.
You'll need more than you think. I used 8 bottles on the bottom tub, hood, inner fenders, and front clip.
You have a build thread out there? Always like to see other fiber builds
That looks really good. I see you made your front inner clip removable. I did the same thing and it sure makes the access to the engine compartment a whole lot easier. I am getting ready to do the raptor liner as well so if you have any tips, they would be appreciated. Ken