Community
Message Forum
Photo Gallery
Event Calendar
Book Reviews
Bronco Wallpaper
Bronco FAQ
Link Back to CB!
Photo Gallery
Event Calendar
Book Reviews
Bronco Wallpaper
Bronco FAQ
Link Back to CB!
Buy / Sell
Bronco Tech
3 Arm Wiper Setup
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
-
Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!If you have problems registering or can't log into your account, please contact Admin.
Group Buy on 3-Row Champion Radiators!
- Thread starter JDJ
- Start date
bronco loco
It never ends
The lower inlet on the driver side of the Champion rad is 1 3/4 diameter while the bronco original radiator inlet on the driver side is 1 1/2 diameter. I already have the hose you suggested but it doesn't fit on the 1 3/4 neck of the Champion radiator
bronco loco
It never ends
Ok found a hose that will fit on my bronco with no body lift using the Champion with the 5.o conversion. Dayco c70445 from a 1996 Ford E-150 Econoline 4.9 engine, just cut off about 2 inches off the radiator side. The upper hose is off a Bronco II 1989 manual tranny LOWER hose. Hope this helps.
Attachments
Similar threads
