bushman_22
Jr. Member
The axle bearings I used were National 514003.
Bushman
Bushman
Community
Message Forum
Photo Gallery
Event Calendar
Book Reviews
Bronco Wallpaper
Bronco FAQ
Link Back to CB!
Photo Gallery
Event Calendar
Book Reviews
Bronco Wallpaper
Bronco FAQ
Link Back to CB!
Buy / Sell
Bronco Tech
3 Arm Wiper Setup
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
-
Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!If you have problems registering or can't log into your account, please contact Admin.
Lincoln Mark V's rear disk build, ran into clearance snags, Bushman Help?
- Thread starter mofoco1
- Start date
OP
OP
mofoco1
Bronco Guru
Chris any chance of getting a picture of the top few of your caliper on the bracket? I would like t o see how far the caliper seats in the bracket from the side looking inwards. With the .25 it is a 1/16" to inboard, I ground the bolt mounts on the bracket per your instructions...Mo
