Part number for Explorer heater tube to heater core

[JSmall]

For any of you that have done this recently, do you have the part numbers you used? I searched and found a few part numbers, but want to confirm before I purchase.

Thanks,

 

[garberz]

Those are only available if you can find good used, or NOS. I found one NOS and it was about $150. I don’t have the part#, sorry. This was three years ago.

Mark.

 

[sykanr0ng]

For what year?
There were some changes that may matter.

 

[JSmall]

Those are only available if you can find good used, or NOS. I found one NOS and it was about $150. I don’t have the part#, sorry. This was three years ago.

Mark.

I’m not looking for the hard line that runs along the intake. I need the molded hoses that run between the hard line and the heater core.

 

[JSmall]

I didn’t describe what I needed very well. Sorry about that

 

[garberz]

I didn’t describe what I needed very well. Sorry about that

Ok, got it. I just used the non trick, reg hose.

Mark

 

[904Bronco]

Is this what you are looking for Jaromy?

I think it was long hose that I cut sections out of... I will have to look for the part #.

Also you can't use the factory heater control valve. In order for things to line up, the factory one would be in a reverse flow position.

Gates 19070 hose

https://www.oreillyauto.com/detail/...eater-hose/19070/4326309/2001/gmc/jimmy?pos=1

Murray Heater control valve # 74628

https://www.oreillyauto.com/detail/...ve/74628/4522476/2001/gmc/jimmy?q=74628&pos=0

 

[JSmall]

Is this what you are looking for Jaromy?

I think it was long hose that I cut sections out of... I will have to look for the part #.

Also you can't use the factory heater control valve. In order for things to line up, the factory one would be in a reverse flow position.

Gates 19070 hose

https://www.oreillyauto.com/detail/...eater-hose/19070/4326309/2001/gmc/jimmy?pos=1

Thank you! You were able to do both sections with one hose? I have the electric heater control valve so I'm hoping it will work.

https://www.summitracing.com/parts/vta-50507-vua

 

[904Bronco]

Thank you! You were able to do both sections with one hose? I have the electric heater control valve so I'm hoping it will work.

https://www.summitracing.com/parts/vta-50507-vua

Yes one hose...

Yes electric valve will work as long as it is place in proper flow orientation.

Water out of intake manifold > heater core > back to water pump

 

[JSmall]

Yes one hose...

Yes electric valve will work as long as it is place in proper flow orientation.

Water out of intake manifold > heater core > back to water pump

Thanks Doug!

 

[904Bronco]

Thanks Doug!

Anytime Sir ;D.