bronconut73
Bronco Guru
- Joined
- Aug 7, 2012
- Messages
- 9,916
Drove it to get fire wood.
got my long arms installed
Prime and sand and prime and sand and prime and sand......
Stretched it out to measure for flare placement
Beast mode... Looks good Jaromy...
is it stock wheel base? Just looks longer for some reason I do have my glasses on too haah
My Wildhorses disc conversion arrived along with the rampage soft top. Going to install these as well as replace the axle seals on the D30 while it's apart and finish my heater.
...Add Drop Trac Bar on my 2.5" Lift. Track Bar was too long.
Test fitted new Tachometer, everything worked. Connected everything. Got nothing. Might have blown something up in the tachometer. The good news, it lights up and looks cool.
My Wildhorses disc conversion arrived along with the rampage soft top. Going to install these as well as replace the axle seals on the D30 while it's apart and finish my heater.
Blaster heater motor installed Sunday. Working great. Except for heat temp is marginal. Very hot before so something bad happened along the way. Temp gauge is sitting at about 175 degrees. The good news, it blows like a ________ !
'Better is the enemy of good.' I'm living it.
Picked it up from the shop, fresh 4.56s F/R with new bearings, ball joints, u joints, seals and rear brakes. Finally 4x4 again ;D
Now its time to pull the motor, need to change out a throwout bearing and hopefully just an intake manifold gasket to maybe fix some oil consumption issues.