Tech article by Keola Ford (Bronc)
Parts Needed:
There's no turning back, lock your hinge in a vise, and cut away! I used my trusty Dremel w/ a cut-off wheel. Have a bunch of spare cut-off wheels handy, unless you have a strong one. Cut off what was previously the lower ear of the double-eared hinge plate. This is the "ear" with the pointed end of the hinge pin sticking out.
After you've cut all the way through, you should be able to slide and spin the ear off using a vise-grip. I had no problem, but you may need to grind the point of the hinge pin flush to get it off. Your hinge pin may also be sheared, in which case you may need to drill out the old pin. You can get new pins from JBG for $4.00.
The pivoting hinge plate should now be able to slide off the pin. Slide it back on and cut the pin about flush.
The final step is to clean up your cutting work with a grinder and chamfer the pin a little to help guide the door on. Sandblast, paint, or do what you will to finish it up, and grease the hinges.
If you kept track, reinstall the hinges on the opposite side doors and posts, or so that the point of the pins are pointing up. Line up your doors and tighten up the bolts and your done.
Note: More stress will be put on the hinges with this set-up than stock. So if your old pins are looking weak get some new ones. If there's a lot of play in your hinges, you may also want to install new bronze bushings.
Parts Needed:
- Stock Hinges
- New Hing Pins (only if needed)
- Cut-off Wheel(s)
- Grinder
There's no turning back, lock your hinge in a vise, and cut away! I used my trusty Dremel w/ a cut-off wheel. Have a bunch of spare cut-off wheels handy, unless you have a strong one. Cut off what was previously the lower ear of the double-eared hinge plate. This is the "ear" with the pointed end of the hinge pin sticking out.
After you've cut all the way through, you should be able to slide and spin the ear off using a vise-grip. I had no problem, but you may need to grind the point of the hinge pin flush to get it off. Your hinge pin may also be sheared, in which case you may need to drill out the old pin. You can get new pins from JBG for $4.00.
The pivoting hinge plate should now be able to slide off the pin. Slide it back on and cut the pin about flush.
The final step is to clean up your cutting work with a grinder and chamfer the pin a little to help guide the door on. Sandblast, paint, or do what you will to finish it up, and grease the hinges.
If you kept track, reinstall the hinges on the opposite side doors and posts, or so that the point of the pins are pointing up. Line up your doors and tighten up the bolts and your done.
Note: More stress will be put on the hinges with this set-up than stock. So if your old pins are looking weak get some new ones. If there's a lot of play in your hinges, you may also want to install new bronze bushings.