• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

BCB Power Steering Reinforcement Sleeves

Chief Master Sergeant

Retired U.S. Air Force
Joined
Nov 6, 2002
Messages
5,222
For those who have installed these things, how tight do they need to be to the inside of the frame? I have ground the heck out of them and got them to where they will just fit into the frame with some force. My fear is that I might get them wedged in there and not be able to remove them.
 

BroncoDawg

Sr. Member
Joined
Mar 4, 2005
Messages
672
Loc.
Bishop, CA
Far better to have them stay in place than have them fall down if you remove the bolts to service the gear box. Well worth having in place for the extra strength they provide.
 

JohnJohn

Contributor
Bronco Guru
Joined
May 6, 2005
Messages
2,179
Loc.
Richmond
I beleive BC recomends you drill a small hole next to each bolt hole and tack weld the sleeves in place.
I have not put mine in yet but was going to drill out the frame and weld them in.
 

chuck

Bronco Guru
Joined
Aug 14, 2001
Messages
6,474
Loc.
Ingram, Texas
Yes tight is good. I drill a hole over the top sleeve and bung weld it so it does not fall when you pull the bolt. No need to weld the bottom bolts as they are already on the bottom.
 
OP
OP
Chief Master Sergeant

Chief Master Sergeant

Retired U.S. Air Force
Joined
Nov 6, 2002
Messages
5,222
Yes tight is good. I drill a hole over the top sleeve and bung weld it so it does not fall when you pull the bolt. No need to weld the bottom bolts as they are already on the bottom.

So do I just beat them down into the frame now? As tight as the top one is, it's gonna take a lot ot get it in place. I'll let you know how it goes.
 
Top