• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

D20 & AOD Transmission Support

kiteoregon

Full Member
Joined
Nov 21, 2011
Messages
292
I am in the process of installing my 351W with an AOD. I modified the support bracket based on a tech article or post here. I have it most of the way installed, but i can't get the existing rubber bushings between the support and the D20 to fit. The old support bracket used a much larger bolt with a nut and large rubber bushings on either side. With the AA adapter it looks like i need to use a smaller and longer bolt and thread directly into the wings on the AA adapter.

Anybody have pictures or can point me in the proper direction?

Thanks.
 

rguest3

Bronco Guru
Joined
Dec 13, 2012
Messages
3,780
I used a modified crossmember made for the AOD install and the AA Adaptor. I installed the replacement poly bushings kit with the Grade 8 hardware included. I had to grind the edge of one of the large washers to fit flush.

I also had to slot the hole on the Frame mount support so the Crossmember holes would line up. I left the frame mount support with the 4 bolts in place on the frame.
 

fordguy

Contributor
Bronco Guru
Joined
Jan 23, 2005
Messages
6,361
i cut the poly bushings with a miter saw so the they would work. probably ended up being about a 45 degree cut. i will try to see if a have a pic of them installed.
 

mattt

Bronco Guru
Joined
Sep 23, 2006
Messages
3,814
x3....the rubber/urethane stock type bushing needs to be clearanced to work with the AA adapter.

Depending on the age of the AA adapter you have, you might be using 7/16" bolts that do in fact thread into the adapter housing. The earlier AA adapters used a thru bolt with nut like a stock Bronco setup, but the later AA adapter does come with the correct bolts that directly thread into the adapter from the bottom up. That is detailed in the instructions that come with the AA kit. Do you have them?
 

englewoodcowboy

Lick Creek Restorations
Joined
Jul 25, 2010
Messages
4,201
You will have to elongate the holes in your cross member and cut a miter on the poly bushings. AA has a set of bushings they are extremely proud of that taper like a bee hive (used in their reference photo) or you could do as others have stated and miter them yourself. My AA also came with new bolts and new sleeves for the bushings because their bolts are a size smaller than the original.
 
OP
OP
K

kiteoregon

Full Member
Joined
Nov 21, 2011
Messages
292
I got the AA adapter from a member with a modified cross member. I don't have the bolts or documentation. I was thinking a miter would be a good option.
 
Top