F100 4x4 knuckles questions

[BroncoBub]

I have a friend that has a 1977 f100 with dana front end. He would sell me the knuckles on out for $100. Question I ask is will this work on my 75 bronco???

The problem I'm having is when I look up parts for a 77 4x4 f100 I can't find any. I find them for the 77 f150 thou. Any help would be appreciated!

Bub

 

[SteveL]

Was the 44 original to the f-100? See if the knuckles have a part #.

 

[BroncoBub]

Was the 44 original to the f-100? See if the knuckles have a part #.

yes C37936R and C37937L

 

[SHX669]

'77 is a F-150 - Ford went from the f -100 in 1975 ( unleaded gas) I used em on my d-44 . The knuckles are configured a little different where the tie rod connects . It puts the tie rod about an inch lower than the Bronco knuckles do so I went with TRO when I made the swap.

 

[BroncoBub]

'77 is a F-150 - Ford went from the f -100 in 1975 ( unleaded gas) I used em on my d-44 . The knuckles are configured a little different where the tie rod connects . It puts the tie rod about an inch lower than the Bronco knuckles do so I went with TRO when I made the swap.

I thought f150 also until his badging on the cowl above the front fender said F100. I enclosed a picture of the truck.

 

[BroncoBub]

'77 is a F-150 - Ford went from the f -100 in 1975 ( unleaded gas) I used em on my d-44 . The knuckles are configured a little different where the tie rod connects . It puts the tie rod about an inch lower than the Bronco knuckles do so I went with TRO when I made the swap.

So what I'm reading is this will work on my 75 with this setup?

 

[toddz69]

So what I'm reading is this will work on my 75 with this setup?

Yes - it will work fine with the tie rod height and hole size differences noted earlier.

Todd Z.

 

[BroncoBub]

Yes - it will work fine with the tie rod height and hole size differences noted earlier.

Todd Z.

Thanks Todd

 

[SteveL]

Will need the adapters for the taper on the tie rods if you dont go tro or something different.

 

[BroncoBub]

Will need the adapters for the taper on the tie rods if you dont go tro or something different.

Where would I get the adapters?

 

[garberz]

Where would I get the adapters?

WildHorses carries them.

https://www.wildhorses4x4.com/product/Tapered_Sleeves_for_F150_Knuckles/Custom_tie_rods

Mark

 

[BroncoBub]

WildHorses carries them.

https://www.wildhorses4x4.com/product/Tapered_Sleeves_for_F150_Knuckles/Custom_tie_rods

Mark

Thank You, very much appreciated!